Kent · South East
Dry Rot Treatment in Swanscombe
Period homes in Swanscombe are treated for dry rot with methods that protect historic fabric throughout the South East.
Swanscombe and the surrounding area
Swanscombe falls within Kent, South East. That includes the DA9 and DA10 postcode districts. The same team covers Northfleet, Ebbsfleet Valley, Chadwell St Mary, Aveley and Tilbury too.
Working in Swanscombe
Clay soils across much of the South East move with the seasons, which affects anything built into the ground, from walls and bases to drainage. Post-2000 extensions in Swanscombe can block ventilation to older floors, creating conditions for dry rot.
Remote properties near Swanscombe benefit from regular checks of gutters and roofs to prevent damp and rot. Barn conversions outside Swanscombe may have historic timbers that need careful, conservation-led treatment.
Our services in Swanscombe
Opening Up and Removal of Decayed Timber
Floorboards, skirtings and plaster removed to expose the outbreak, with decayed timber cut out and bagged for safe disposal.
Fungicidal Treatment of Timber and Masonry
Targeted boron-based or other approved fungicides applied to remaining timber and masonry near the outbreak to stop regrowth while walls dry.
Structural Timber Replacement
Joists, wall plates, lintels and floorboards replaced with pre-treated timber, isolated from damp masonry and fixed to suit the structure.
Replastering and Reinstatement
Walls replastered, floors relaid and joinery refitted once the structure is dry and sound, with breathable finishes in older homes.
Dry Rot Survey and Identification
A specialist inspection to confirm dry rot, distinguish it from wet rot, trace the moisture source and map the full extent of the outbreak.
Moisture Source Repairs and Drying
Leaks, blocked ventilation and bridged damp barriers fixed so the building dries out and the fungus cannot keep growing.
Guide prices for Swanscombe
- Small localised outbreak: £1,000–£2,500. Limited area such as a skirting and a few floorboards, with treatment and reinstatement.
- Dry rot survey and report: £200–£450. Specialist inspection to confirm dry rot, map its extent and identify the moisture source.
- Replastering after treatment: £60–£130 per m². Lime or modern plaster once walls have dried, depending on the system used.
Prices are a guide. Your quote for Swanscombe is a fixed price based on the details you give us. Full price guide.
Dry Rot Treatment questions from Swanscombe
Is dry rot common in Swanscombe?
Dry rot can occur in any Swanscombe property with long-term damp, especially older homes with timber built into walls and poorly ventilated floors. Leaks, blocked air bricks and gutter problems are common causes.
Can you treat dry rot in a listed building in Swanscombe?
Yes, though you may first need listed building consent from Kent. Specialists use conservation-led methods that remove only what is necessary and focus on drying the building to protect historic fabric.
How quickly can a specialist visit my Swanscombe property?
Specialists can usually inspect properties in Swanscombe within a few days to a week. If you have found active fungus or structural damage, mention it on the quote form so the visit can be prioritised.
How much does dry rot treatment cost in Swanscombe?
Dry rot treatment in Swanscombe typically costs £1,000–£2,500 for small outbreaks and £3,000–£7,000 for a room with joists affected. Extensive outbreaks can cost more. A survey usually costs £200–£450.
Does dry rot come back after treatment?
Dry rot should not come back if the moisture source is fixed and the building stays dry. Regrowth usually happens when leaks return, ventilation is blocked again or the original cause was not found. Keep gutters, plumbing and air bricks in good order after treatment.
What is dry rot?
Dry rot is decay caused by the fungus Serpula lacrymans, which attacks damp timber in buildings. It can spread strands across masonry to reach new wood, causing timber to shrink, crack into cubes and crumble. Despite its name, it needs moisture to grow, usually timber above about 20% moisture content.
Helpful guides
What Happens During Dry Rot Treatment? Stage by Stage
Dry rot treatment follows clear stages: a survey to confirm the fungus and map its extent, fixing the moisture source, opening up floors…
Read the guide →Dry Rot in Listed and Period Buildings: A Conservation Approach
In listed and period buildings, dry rot is best treated by fixing the moisture source, drying the structure and removing only decayed…
Read the guide →Get a free dry rot treatment quote in Swanscombe
Tell us what you need and we'll come back with a clear price.
Request a quote