Dry Rot Treatment

Guide · Homeowners · 4 min read · Updated 17 November 2026

How Much Does Dry Rot Treatment Cost in the UK?

Short answer

Dry rot treatment in the UK costs £1,000–£2,500 for a small localised outbreak, £3,000–£7,000 for a single room with floor joists and £7,000–£20,000 or more for a multi-room or structural outbreak. A specialist dry rot survey costs £200–£450, joist end replacement starts from £150 per joist and replastering after treatment costs £60–£130 per m².

How Much Does Dry Rot Treatment Cost in the UK?

Dry rot treatment prices

Dry rot is one of the most expensive timber problems a building can have, mainly because the true extent is rarely visible at first. Serpula lacrymans spreads behind plaster, under floors and through masonry, so the cost depends on how much of the building has to be opened up, how much timber has to be replaced and whether structural elements such as joists, lintels or roof timbers are affected. A small outbreak caught early may cost no more than a modest kitchen repair. A long-established outbreak in a damp Victorian basement can reach five figures.

The prices below are typical 2026 guide figures for UK properties. They assume the moisture source is being fixed as part of the work or separately.

WorkTypical priceWhat is involved
Dry rot survey and report£200–£450Confirm dry rot, map its extent, identify the moisture source
Small localised outbreak£1,000–£2,500Skirting and a few floorboards, treatment and reinstatement
Single room with floor joists£3,000–£7,000Opening up, removing decayed joists and boards, replacement
Multi-room or structural outbreak£7,000–£20,000+Several rooms, lintels or roof timbers, often with an engineer
Joist end replacementfrom £150 per joistCut out decayed ends, splice or replace, isolate from masonry
Replastering after treatment£60–£130 per m²Lime or modern plaster once walls have dried

What drives the cost

The extent of the outbreak is the biggest factor, and it is often only fully known once floors are lifted and plaster is removed. Good contractors price in stages, with a clear rate for further work if more decay is found. Structural involvement adds cost quickly, because decayed joists, wall plates, lintels and roof timbers need replacing with pre-treated timber and may require a structural engineer to design temporary support and permanent repairs.

The moisture source matters too. If the outbreak was caused by a leaking roof, a defective gutter or a long-term plumbing leak, that repair is often a separate item. Listed buildings and period properties may need more careful, conservation-led methods that take longer and preserve as much historic fabric as possible.

  • How far the outbreak has spread behind plaster and under floors
  • Whether joists, lintels or roof timbers are structurally affected
  • Need for a structural engineer and temporary propping
  • The repair needed to fix the moisture source
  • Replastering, joinery and decoration to reinstate the rooms
  • Listed or historic status requiring conservation methods

Worked examples

A small outbreak found behind a skirting board next to a leaking downpipe might involve removing a metre or two of skirting and a few floorboards, treating the surrounding masonry and timber, fitting new pre-treated boards and skirting, and replastering a small area. That kind of job typically falls in the £1,000 to £2,500 band, once the downpipe is fixed.

An outbreak in the front room of a Victorian terrace with a suspended timber floor, where several joist ends and the wall plate have decayed, is likely to cost £3,000 to £7,000. The floor is lifted, decayed timbers removed, the wall plate replaced or the joists supported on new hangers, sub-floor ventilation restored and the room reinstated. Outbreaks that have spread into a second room or up into the structure above can push the cost well beyond that.

Why early action saves money

Dry rot grows for as long as the conditions allow it. Each month an outbreak is left, it can spread further into timber, along masonry and behind finishes, turning a repair of a few thousand pounds into a far larger job. The good news is that dry rot needs damp to survive. Fixing the moisture source quickly and allowing the structure to dry stops new growth, even before the decayed timber is removed.

If you suspect dry rot, arrange a specialist survey promptly, find and fix the leak, and avoid disturbing the fungus more than necessary until it has been assessed.

Even a temporary fix, such as a bucket under a roof leak or a patched downpipe, helps while you wait for the survey.

Getting quotes and comparing them

Because so much can be hidden, quotes for dry rot treatment should be based on a survey that sets out what was seen, where opening up is needed and the likely extent. Ask each contractor to price the same scope, including removal and disposal of decayed timber, treatment of timber and masonry, replacement timbers, replastering and joinery. Ask how they will handle extra work if more decay is found, and at what rate.

Be cautious of quotes that rely on heavy chemical treatment of large areas without addressing the moisture. Modern practice focuses on removing the damp and the decayed timber, with targeted treatment where it is needed.

Dry rot and selling a house

An untreated dry rot outbreak will almost always be picked up by a buyer's surveyor, and it can stall or collapse a sale. Lenders often hold back part of the mortgage until the problem has been investigated and repaired. Dealing with it before marketing gives you control over the cost and the timing, rather than negotiating under pressure.

If dry rot has been treated in the past, keep the survey, the invoice and any guarantee together. Sellers in England and Wales are asked about timber treatment and guarantees on the TA6 property information form, and clear paperwork reassures buyers that the problem was handled properly.

Questions people also ask

Is dry rot treatment covered by home insurance?

Most home insurance policies exclude rot, including dry rot, as gradual deterioration. If the rot was caused by a sudden insured event such as an escape of water from a burst pipe, some damage may be covered. Check your policy wording and speak to your insurer before work begins.

How long does dry rot treatment take?

A small outbreak can be dealt with in a few days. A single room with joist replacement often takes one to two weeks. Larger structural outbreaks can take several weeks, especially where an engineer is involved and walls need time to dry before replastering. The survey should give a realistic programme.

Can I get a guarantee for dry rot treatment?

Many treatment firms offer long-term guarantees, and some are insurance-backed so they remain valid if the firm stops trading. A guarantee normally depends on the moisture source being fixed and the property being kept in reasonable repair. Keep the paperwork, because buyers' solicitors usually ask for it.

Written and checked by the Dry Rot Treatment team. Read our editorial policy.

Get a free dry rot treatment quote

Tell us what you need and we'll come back with a clear price.

Request a quote